#Mackie onyx satellite windows 10 driver install
#Mackie onyx satellite windows 10 driver drivers
#Mackie onyx satellite windows 10 driver update

I paid $150 for this little thing at Guitar Center. I use the Korg Padkontrol, emu xboard 61, Emu Command station,Roland Sp606

#Mackie onyx satellite windows 10 driver drivers

All the drivers are installed correctly adn my FW port is fine, as though I don't know who makes it. I updated the drivers already, I will post back if I find a solution I still can't hear anythingĭo you have the Metronome during recording/playback enabled in SONAR?) (Sorry for all the questions), in the Control Room section for SOURCE have you tried toggling between DAW and Inputs). Yes I'm using ASIO, and YEs the drivers are selected in SONARĪre you monitoring through headphones connected to the Onyx satellite or Speakers connected to the Onyx Satellite (and are you unable to hear the audio metronome with either of these monitor setups)? How is your MIDI controller connected to the PC (USB or what)? I'm using the MIDI connectivity of my Delta 1010LT, and as I said, there is a definite improvement with the latency I can now get after applying the satellite firmware update.ĭo you have the Mackie Onyx Satellite set as the default windows playback and recording device (via Sounds and Audio devices properties dialog/Audio tab and Voice tab)?Īre you using the ASIO driver? Are the Mackie drivers selected in SONAR (Options/Audio drivers tab)? It's said that a Texas Instrument make of firewire works better than other makes. What make of IEEE 1394 port are you using.

#Mackie onyx satellite windows 10 driver install

Were the satellite drivers installed properly, Instructions say install software 1st, then connect the firewire cable with the satelite On when prompted. A more knowledgeable user may reply as well. Post back if you find the solution to your problem? We'll have to figure this out.

#Mackie onyx satellite windows 10 driver update

Here's the link to the drivers and updater: Īfter making the firmware update my latency setting are prettey low, even to the 1.3ms setting with a multitimbral synth and 3 or 4 parts. I'm using the latest driver (Satellite v1.7.2) and the latest firmware update for Windows (SatelliteUpdater). Are you using the ASIO driver? Are the Mackie drivers selected in SONAR (Options/Audio drivers tab)?Īre you monitoring through headphones connected to the Onyx satellite or Speakers connected to the Onyx Satellite (and are you unable to hear the audio metronome with either of these monitor setups)? Do you have the Metronome during recording/playback enabled in SONAR?) (Sorry for all the questions), in the Control Room section for SOURCE have you tried toggling between DAW and Inputs). is selected for things to work in SONAR right. Do you have the Mackie Onyx Satellite set as the default windows playback and recording device (via Sounds and Audio devices properties dialog/Audio tab and Voice tab)? Not that that is needed, but I have 2 sound cards and sometimes I have to make sure the Mackie Onyx Sat. I'm using SONAR 7, and I can hear the Audio Metronome (count in also).